« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: Z9 Failure  (Read 1393 times)

Erik Lund

  • Global Moderator
  • **
  • Posts: 6334
  • Copenhagen
    • ErikLund.com
Re: Z9 Failure
« Reply #30 on: March 23, 2023, 12:31:39 »
Thank you for sharing!
Logged
Erik Lund

Gone

  • NG Member
  • *
  • Posts: 141
  • No longer wish to be ignored
Re: Z9 Failure
« Reply #31 on: March 23, 2023, 13:55:20 »
Not too bad then - I see Nikon refer to it as a shanding unit (sic)  - I wonder if that should be shading!
Logged

Dogman

  • NG Supporter
  • **
  • Posts: 347
  • You ARE NikonGear
Re: Z9 Failure
« Reply #32 on: March 23, 2023, 13:59:37 »
The unit did do its job after all.  Protected the sensor and prevented damage.  Too bad it was so expensive but it's sort of like the cost of replacing the bumper on a modern automobile--very costly but less than replacing other body parts.
Logged
"If it's more than a hundred feet from the car, it's not photogenic."--Edward Weston

My Photos: https://www.flickr.com/photos/197057338@N03/

golunvolo

  • NG Supporter
  • **
  • Posts: 6083
  • You ARE NikonGear
Re: Z9 Failure
« Reply #33 on: March 23, 2023, 17:12:30 »
Menos mal...uf.
 

  Not bad at all.
Logged
Pages: 1 2 [3]   Go Up
« previous next »