PC 19mm f/4 E ED

[Erik Lund]

Very nicely captured!, Also an amazing building!

[Sören Hese]

wonder if someone tested the 19 with the TSE FRAME: https://rogeti.myshopify.com/products/tse-frame from ROGETI. This aluminum frame was designed for the Canon TS-E 17mm but it should fit to the 19mm from Nikon. Seems as if nobody did it so far - at least there is nothing in the net.
I also wonder why Nikon didnt provide a rotating tripod collar design for this lens. It would totally make sense and would make it much easier to harvest the full potential of the lens (parallax free compositon of panos & diagonal shifting). Some shots from some architecture training shots with the 19 ...  - well one is a 14-24 pano :)   

[bobfriedman]

I didn't think the 19 T/S was that tolerant to direct sun... (even with the flare).

[Sören Hese]

I didn't think the 19 T/S was that tolerant to direct sun... (even with the flare).

Well the last shot is from the 14-24 (F-mount version). The first and the second shot however are from the 19. It handles against the sun better than my 14-24 imo but I havnt tested all sun positions in the frame.

[MILLIREHM]

wonder if someone tested the 19 with the TSE FRAME: https://rogeti.myshopify.com/products/tse-frame from ROGETI. This aluminum frame was designed for the Canon TS-E 17mm but it should fit to the 19mm from Nikon. Seems as if nobody did it so far - at least there is nothing in the net.

Thanks for the link. But that the  Frame would also fit the Nikkor 19mm lens is currenty a guess and not yet confirmed, right?

[Sören Hese]

Thanks for the link. But that the  Frame would also fit the Nikkor 19mm lens is currenty a guess and not yet confirmed, right?

yes! pure guess from the dimension and the support elements of the TSE FRAME. There is likely some adaption needed. Someone mentioned that it fits also to the Nikon here: https://www.dpreview.com/forums/post/65386448, but that is the only source I can find. But looking closely at the design of the TSE FRAME its obvious that it was very precisely created for the Canon and its nobs.

[Sören Hese]

I have to correct my statement. The DPREVIEW comment was linking a collar from iShoot and NOT the TSE FRAME!

[Lewis3000us]

Hi Erik Lund,

As a first time owner of a PC NIKKOR 19mm f/4E ED, I was delighted to see the good idea you posted in late 2016 about using a modified LC-K101 with this lens.  I have located an LC-K101 and will be trimming it shortly so I may use it with my PC 19mm.

I noticed it falls off the lens when bumped slightly.  And I see you mentioned, “It will just need a tiny trimming to lock at the right point since the original lens cap LC-K101 has a small locking hatch.”  I’m assuming the hood falls off easily because I have not done the tiny trimming yet and that must be why it does not rotate on very much.

Can you kindly elaborate a little about how you did this trimming?  Was it to both sides, or just one side?  Does it correspond to where the latch is on the lens cover?

Thank you much.
Tom

[Erik Lund]

It's on both sides of the hood, so the two small notches in the lens hood will fit the below ridge marked in blue

[Lewis3000us]

Thanks, Erik.  I’ll review.